Newly designed J’s Racing Camber Joint CAJ-S1-S2
By redesigning the previous model, the new camber joints have been enhanced with the roll center adjuster function in addition to the original negative camber adjustment.
Material : Forged aluminum 6061
The surface is anodized red with a laser carved ‘J’s Racing” seal
Ball joint S45C
Boll stud SCM435 HB195-260, Fluctuation angle 33 degree all around
The front camber angle can be adjusted to the stock + 3 degree
The front roll center value can be adjusted back to the correct one.
The insufficient negative camber is always a problem for S2000. This product creates enough negative front camber by locating the lower ball joint at an eccentric angle from the center.
The product also corrects the front lower arm position back close to horizontal, so that the correct geometry is restored with the accurately adjusted roll center.
[When you reduce the ride height, the front lower arm position becomes like a separated letter V]
It works in a variety of driving situations from the street to the race track.
It is a must-have item for a spirited sport driving with S2000.
- Adjustable range: 3 to 5 degrees
- Ride height: Recommended to the vehicle whose height is reduced more than 40mm
- Included in the kit:
- Camber Joint S1 x2
- Clip x2
- Castle nut x2
- * The stock bolts are to be reused or use new stock ones.
Please apply the correct tightening torque. After the installment, it is necessary to properly adjust the ride height and alignment.
It is highly recommended to check the tightening condition of the bolt & nut periodically.
[Always check it before the track event or race]
Shipping is about 60-90 days